Z4 Power Convertible Had a problem with my '03 Z4 power convertible last year. It would not fully latch when closing. Took it to a reputable private shop specilaizing in German cars and they replaced a sensor. Many problems starting with BMW changed the original part to a newer version and the group did not have the software to program the new

1st thing to try is resetting it. I did hit some debris in the road but i didnt think it was enough to effect anything. Just press the reset button and hold it for a few seconds. It will reset. If it comes back on again then either one tyre (on the same axle) is a different pressure or you have a system fault.

well, almost exactly 1 year and 10,000 miles later, I was switching back to summer wheels, and I noticed my passenger rear spring was broken. The spot where it's broken doesn't cause the passenger side of the car to ride more than 1/4" lower than the driver's side, and I don't really notice any issues while going over bumps.

Is it a common problem ie BMW contribute to the cost of repair? Gutted . Top. bcworkz ↳ E89 problems; ↳ How-To; E85 / E86 Z4 Discussion (2003 - 2009)
Newport, South Wales,UK. Model of Z. Z3 M43 1.8 (1999) and Z4 E85 2.5 (2003) Oct 19, 2018. #9. Best practice is to set the heater to fully hot before you start the car, ensures the heater circuit is in play. With the car raised as high as you can get it at the front, run it and bleed it via the bleed screw. XrPH.
  • berisc8wgj.pages.dev/53
  • berisc8wgj.pages.dev/41
  • berisc8wgj.pages.dev/113
  • berisc8wgj.pages.dev/79
  • berisc8wgj.pages.dev/264
  • berisc8wgj.pages.dev/19
  • berisc8wgj.pages.dev/164
  • berisc8wgj.pages.dev/359
  • berisc8wgj.pages.dev/106

    • bmw z4 e85 common problems